Sadly life has taken me a different route and I cannot put all of the work I planned on doing to this vehicle anymore. Bought off a fellow mud member and it was my daily driver for almost 2 years and really never had a problem with it. It had an overheating issue at one point and I replaced...
So I just cleaned the posts and cables and it started right up! It seems like it's idling at lower RPM's now but everything seemed fine on the little spin I took right after so I'm content for now. Thanks so much everyone for your advice!
Hey everybody, I tried looking through multiple starting problem threads but didn't see my scenario so I figured I'd ask. My cruiser has never had an issue starting or going dead or anything. Fired up perfectly fine this morning like it always does and park it. The day goes by and when I get in...
Think I just figured out my own question. For whatever reason I was thinking the TC was a manual shift but just realized that its electric. That makes a lot more sense then
Thanks for the reply. My intentions would be to only use the body off of my 62 and use everything else off the 80. Am I just being dumb about the placement of the shifters or drawing a blank? On the US 80s, LHD, the gear selector is closer to the driver and the TC is further away. On the RHD 80s...
Hey guys this might be a silly question but I couldn't seem to find an answer so I'll ask. I'm in the early planning process of my build and after seeing multiple builds I think I want to do the 60+80 mashup. My intentions are to get an HDJ81 and put the 1HD-FT, tranny and TC into my 62.
So my...
Well the transfer case fluid has been changed and I took it for a quick drive and it definitely sounds better. I'm also going to change front and rear differential fluid while I'm at it just because I bought extra. Hopefully that clears up a little more noise as well. Below is what came out of...
Thanks for the response. I was thinking about the rebuild and looked into the process and watched a couple videos and it didn't look too bad. The only issue I could possibly come up with was not pulling the transmission to rebuild it and possibly the press needed. I just wasn't sure if there is...
Hey everyone, been lurking on here for a long time but have finally made the first step of my end goal. About a month ago I bought a 1988 FJ62 from a member on here, Orion, and I couldn't be happier with it. I've done a few cosmetic things to it but nothing major as of yet but I am looking to...