Recent content by skipdup

Oh yeah. We heard. We were crying. My son is still cracking salmon t-shirt jokes. You guys were running privacy tones, right? New to gmrs and wondering why you guys couldn't hear me...

I think we (white Jeep) passed some of you guys (mainly 60s) yesterday on Imogine as you were leaving the summit. We could hear you on ch 16, but couldn't respond. You guys were freakin hilarious! We almost turned around just to keep you in range. Salmon colored shirt, bedazzled jeans... PURE...

Just ordered 2. Thanks!

OK. I think I got it. Front at 6.8. Rear at 6.8. Accum Presssz came back after plugging back in - 10.1. Thanks all...

Is it normal to get a zero reading for the Accumulator Pressure Sensor while the Temp Sensor is unplugged? I've consistently gotten ~10, until I disconnect the rear sensor. Thanks!!

Thank you!

It seemed like a definite improvement. Maybe??? Not sure if it was confirmation bias or not.

How does one "disconnect the AHC temp sensor"? Sorry, I bet it's in here somewhere, but I can't find... I did and AHC flush, new rear springs, and adjusted the front torsions yesterday. Checked pressures again today (as sanity check). Apparently, I'm not sane. :) Front changed from 6.9 to...

The working TMPSs are still in a pressurized PVC tube rolling around in the back. :)

Originally, I bought p/n 550-0191, but those didn't work either. Finally, got p/n 550-0103, and they worked immediately. IIRC, the confusion had something to do with my month (in 2006) of manufacture. 2006 LX470. Good luck.

Mine ended up being the wrong sensors. Once I got the right ones, the process worked like clockwork...

I'm trying to find min. rear rotor spec for 2006 LX470. Can I use '04 LC spec found in the FSM? If so, can I use the rest of the brake section was well? THANKS!! Skip

@Sbfreerider THANK YOU! That helps a ton!

TechStream finally let me see the Data List (after a few more tries???). Shows what I entered for each sensor, but no data. An old screen capture for reference attached. Does anyone know how the ID works on these? The 2 numbers etched into the sensor... The top one is too short and the...

@OEMGUY0720 Well, I've been distracted with family stuff. But, you're post kick started me back... I toyed around some with it today. But, I'm afraid I've taken a few steps backwards. Have no idea what I'm doing, what's wrong, etc. :) I put the denso sensors in a PVC pipe & pressurized to...