im in the process of putting a 2" ironman lift in, and dislike the shackle angle also, i wish the damn things were an inch or 2 longer
havent driven it though... but it worries me, i need the 2" lift, the only way the shackle angle can improve is...
Started tearing into her, got the aux fuel tank out, I'm adding a fuel sending unit, and a vent because I'm having a hard time filling her up without spilling.
Also working on the engine, replace all hoses and some of the wiring.
i got some rust under the dashpad that im trying to address, havent figuered out how to preserve the rest without being all sticky from fluid film, but i read about PB Blaster undercoating, and that it stops creeping after a while. im thinking i...
soo reading trough this it seemed like the FJ and the garage looked familiar :) im the guy that picked up that roll cage a few weeks ago!
ill be following your progress...
does anyone know where to get the pull handle? ( Edit: found out that its unobtanium for a 73 )
also... couldnt toyota have made the nut and bolt for the vent plate not any smaller? i broke the threads clean off...
That is my pet peeve. With any job, you put in random fasteners and I start cussing. Helping my father-in-law, I replaced a failed mini tankless water heater under his sink. Installed by a "pro." Of the four screws used to mount it, I needed...
btw i wished that was the only screwup the PO did... i think he robbed a hardware store full of random size bolts and then went over to advance auto to buy cheap s*** to make the V8 run....
as much as i like the power, im considering putting a...
that is correct, was upside down when i bought it, the Wife then proceeded to make awesome pictures of it before i had the change to fix it.
the pictures of the new bumper show its correct again :)
best bet with the brakes is to swap outers from a 76 and later 40 so you can have disc brakes.
I don't know what aftermarket tanks go for but Toyota still makes yours, about 475 I believe
still chugging along.. :) fixing minor things here and there
after reading some of the patina threads, i guess im gonna try the CLR thing and see how shes going to look.
i found out the 4x4 didnt work because the transfer case is busted, the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.