Under hood is stock. Aluminum Champion radiator with separate Jegs trans cooler. PO cut the A/C lines at firewall and made a custom battery tray out of wood by cutting the inner fender. I saved the inner fenders from my parts truck to correct that. Just haven't gotten to it.
I have original carpet from a truck I parted out, as well as all the rear panels/factory speakers. Although, the boom box speakers and stained plywood from the PO are a pretty classy upgrade. Also have a big swatch of original seat material. If someone wanted to fix that seat upholstery
$4900... Pretty rusty, but I've seen worse...(and many better!) Rear frame sections should have stiffeners removed/replaced or just box the frame back there. This truck is fun "as-is" I'm not sure if it's worth fixing up. It could be made better with some work, however it will never be a "NICE"...
Its not a perfect piece, but its off the truck and ready to ship. This core support was removed from a (non-wrecked) 1988 FJ62. The support does have some rust through near the bottom, See pics. I think it is very repairable if someone desired to mess with it. It can also be used "as is" to...
All doors are really rusty. Core support is OK but I might not have the time to pull it, unless it was paid for. I did start pulling some smalls. I get it, I would like someone else to come get it. Not excited about sending it to scrap.
For parts (obviously) What you see is what you get minus bumpers. Floors are great. Frame is typical Ohio rust. No drive train at all. Its sitting on the leaf springs. A tree hit the roof near the front passenger side. If you see anything that you may need, message me but I would rather sell...
If you need a hood for a beater 60 this may work. Unfortunately someone cut a hole in a perfect hood and did a poor job riveting a hood scoop on. Will take $75 local pickup. Text me at 614-638-0882 if you need addn'l pics.thanks. Scott
Brass front heater core original to 1988 FJ62. I pulled this from a non-running truck so it is un-tested. It would be a good core to test and possibly do the solder mod to delete the plastic connections and then you could swap immediately if you have one leaking. I can remove from plastic box to...