I installed both new pads and rotors and rear brake is adjusted correctly.
I always concern about brake system and check, adjust and lublicate regularly.
I drove about 22k miles after pad/rotor changing and The rotor and pad worn very evenly.
Brake pad wear is affordable but rotor wear is...
Hi,
I installed DBA 4000 series rotor(club spec.) with PBR ceramic pads on 17MAR2007, both were bought from MAN-A-Fre.
I satisfied with their perfomance and enjoyed.
After 14 month of using, I checked pads wear and think it's time to change pads.
But I also found rotors also worn so much...
I installed FJ80's Brake Master Cylinder today.
I bought this from Man-A-Fre because on their webpage, their FJ80 M/C's photo is AISIN's which is OEM of Toyota M/C.
But M/C which I received was made by another aftermarket vender. :frown:
I hope MAF should change photo to prevent to be cheated...
I'm using 1992 FJ80's booster with OEM FJ62 master cylinder about 3 years without any problem.
And next weekend, I'll swap my original 62 master cylinder to 80's cause old M/C needs to be rebuilt or change now.
I know can just rebuild old M/C but I don't like cast iron cylinder bore which can...
My 1988 FJ62 had front passenger side bench seat also. But I need center console that I removed it.
I'd get passenger seat and center console from USA FJ62 and installed them into my Non-USA FJ62.
Hi, mud members,
I need help about how can I distinguish windshield wiper arm between RH and LH.
I'd aparted wiper arm without pre-marking that can't determin which one is driverside and the other is passenger side.
I watched wiper arm carefully and the only difference I could find is...
1. Move your truck to safe place.
2. Place the tranny position in neutral.
3. Press the brake and clutch pedal and hold then start the motor.
4. Move tranny position to 3rd gear. (still hold the brake and clutch pedal)
5. Release the clutch pedal slowly. (still hold the brake pedal)
6. If...
I'll answer shortly.
1. OEM(AISIN) cause less trouble than any other 3rd party carb.
2. I don't know about distributor because my preference is oem contact point type ignition ;)
Regarding ignition wire and spark plugs, I'v used oem, Bosch, Autolite, and etc but couldn't distinguish the...