Sando Serious

I recreated the stock type bracket to add rear shoulder belts to an ‘82 I used to own.

I have a full cage and looking for a set up for the rear to use 3 point belts with a Con-Ferr bench seat. Something like below looks like it'd be a good option, but they're only 1.75" and I need 2". (found on REAR SEAT 3 POINT SEAT BELT HARNESS...

Every time I take the hardtop off I've always thought it was strange/funny that Toyota engineers missed adding factory seatbelt anchor points when the top is removed. I have a 1/78 and with the top on there are anchor points for the upper and...

Any photos of how this turned out? I’m kinda looking for the same solution. Did you use the bracket in the original photo you posted?

Thanks! I was able to figure it out with some previous guidance, but I'm fairly certain there was a grounding issue. All is good now!