Saleem

Yes it does seem that’s the case

Based on this i seem ok..

I've got this diagram but it could be better.

Checked the FSM and there isn't any note on the amount of passages etc, just states to line up the bushing holes with the passages.

So this is what's there currenlty Bushing has 1 hole and lines up with the oil passage Bushing 2 has 2 holes and only one lines up with the oil passage Bushing 3 has 3 holes and 2 lines up with the oil passage on the block Bushing 4 has 1 hole...

Post #3 https://forum.ih8mud.com/threads/2f-oil-pressure-range-where-to-measure-it.333764/ I believe the #3 cam bearing (bushing) has two holes opposite each other that must align with the two holes in the block. Also, if you replaced the cam...

I’m fairly sure this is how it works. At the number 3 cam journal and bearing, is where oil is delivered up to the rocker assembly. The cam journal should have two holes. With each rotation of the cam, the two holes in the journal align with the...

I'm curious as to how much passages are there in each of the points on the block where the bushings have to be pressed in, there is only one passage lined up in number three however the bearing has 3 holes..

So i've done some searching however can seem to find an answer to what i'm looking for, I had my local machine shop replace the camshaft bushings in my 2F however i suspect they may have incorrectly installed number 3 bushing (counting from the...