Merry Xmas to all.
Rob, a big thanks for pulling off a great Xmas party.
We enjoyed the Clayton Pub as our venue. Food IMO was much better than at Pier 76.
Nice to see a good turn out and it was nice seeing everyone again.
Take care and warm wishes to all.
Mike & Patty
For wood fence post that go into the ground we do the following.
Hole is 3 to 4ft deep. Our frost line depth is 18".
6 in of 3/4 " clear crush.
PT post held up 5-6 from garvel.
Mix concrete in wheel barrow or bucket, fill hole and slope concrete away from the post so no water sits on top.
Have worked in boots for over 40 years....
Work boots have only lasted typicaslly for two years until I bought Viberg's.
My Viberg's are now 8 years old, resoled and re-heeled was $80 CDN thats about $60USD.
By far best boots that I have ever owned. I grease mine with Hubberd's grease.
Swapped my engine to a diesel 1HD-T in my 60. This diesel engine was never sold in Canada or the States.
Parts for the engine aren't readily available here in Canada.
Or our one month trip to the Grand Canyon we had some issues so I purchased many new parts for
the engine. Head gasket...
89BigBlue here you go
Also received my new Wits End fan clutch and a box full of parts that my wife's aunt brought over from Japan. Will be very busy for a bit.
Toyota Part Number for the mirrors are
Mirror Assy, Outer
Installed the new mirrors . The old ones were not adjustable anymore and were fully seized up.
New ones have a convex mirror, much better viewing out of them.
They are genuine Toyota 78 series mirrors.