Recent content by rsc71

Got that pulled out a cpl of days ago and it looked good,so i pulled the pump yesterday and the teeth on the gear are worn.going to check the local dealer if he can get the parts.if not ran across this on ebay NEW OIL PUMP & DRIVE GEAR FOR STIHL 050 051 075 076 CHAINSAW NEW 1111 647 0601 | eBay

bump for Dan :-)

got the tool and got the clutch off and the plate under it.I take it the oil seal needs to come off next?

thanks for the response Dan,I was reading around on the internet and came to the conclusion I will have to get the clutch off.Also read some of your other posts about useing rope(hazards) instead of a piston stop.I may take it down to the saw shop and see if i can get them to take it off for me...

I have a Stihl 051av that recently stoped oiling the bar.I pulled the oil pick up out of the tank to check the screen,it looked good.With the bar off defently dont see any oil being fed threw.

found some,thanks

how much for the motor?

rear springs if they didnt go with the axles

looking for stock rear springs

looking for stock rear springs

rear springs? i didnt see mention of them being sold,was it stock with no lift?

SOLD!!!

To the top

SOLD!!!

was talking with this guy about trading for a 40 i have but we didnt,he has it up for sale...Ca though 95 Toyota Land Cruiser - NorCal - Pirate4x4.Com Bulletin Board