Recent content by rocrawler

I've got one out of a earlier FJ40 (1968-1972) out in the garage. When I get a chance I'll get the measurements for you.

On the semi-floter rear end on all my FJ40's they run in the gear oil. No need to pack any of the bearings with grease.

early two piece hood hinge Don't worry about it. I send them out the middle of next week. hope you had fun at Moab this weekend, wish I could have been there.

early two piece hood hinge I know that some of the ones I got have BJ25 stamped on them.

The front clip is off of a 60' FJ25 so it has the 3 bars and headlight trim insted of a bezel.

early two piece hood hinge I found 5 of the early hinges, enough to make 2 sets and 1 spare. 2 of them are still attached to the hood, no you don't get the hood, and I know a couple of them are pretty worn. PM me your address and I'll send them to ya if ya want them.

early two piece hood hinge Ige, I think I have a couple of pairs of the early hinges. If I find them they are yours.

And finally a pic of the side of the bed with the cab in the background.

Here's the rear of the bed with the final paint.

Here's some pictures of my 64' FJ45. I'm in the middle of painting it right now.

Re:need hard top! P.S. I'm located 250 miles north of Las Vegas, NV

need hard top! I've got one from a mid 60's FJ40. It's in decent shape, the rear hatch needs the handle. I can e-mail some pictures if your intrested. $150 and I will not ship

Make sure your shocks aren't bottoming out.

need'em 3speed tcase housing thingy Let me get this straight. Is what your looking for the nose cone, the front alum. part of the t-case that bolts to front driveline on one end and to the t-case housing on the other? If that is the case then you can use any 3sp t-case nose cone and your inner...

Re:Still need inner seal birfield steel split ring Try your Toyota dealer. That's where I got mine when I did my disk brake conversion. They are like a $1 apiece IIRC