As a US 70 series owner for nearly 20 years I have a few comments. 70's, should be cheap. You can essentially buy new doors any day of the week anywhere in the world. Many aftermarket (and OEM) sheet metal panels can be found. UAE sources make...
five 79 series wheels fit 100 series and 2007+ 5 lug tundra/sequoia.
in Tucson, making a trip to southern phx next week $350
I agree with eco as a 77 donor or 75 troopie would be better donor for 79 sheet metal than most others.
coil front ends have to wait til 1998 models
rear springs can be converted to parabolics for ride.
easy to mount transmission, but you have to have a 3B/13BT input shaft AND input bearing retainer which parts are clearly shown above.
I would advise starting a new thread in the 40 series area AFTER reviewing all "putting H55 in a FJ40 "...
the 60850 AND the 60450 h55 will accept the 60111 input shaft. Also remember to get the 33131-60050 bearing retainer. Buy the least expensive new transmission.
Not to add confusion, but the top plates are different from 60/70 series to 40...
The input shaft of the B/3B is a very long 21 spline unit.
The input shaft of 1HZ is shorter 21 spline
(...and the bandierante is very short 21 spline).
Your best option is to find a 3B input 33311-60111 from 1986-1993 H55 or H41 (4.8:1...
the 4 speed transmission looks to have an open bearing which might be the earlier style so you would be unable to move shafts between the two transmissions. Georg is correct, measure the two input bearings.
Original, a B engine H55 cut down with...
pure and simple answer, as soon as you touch a data tag you can get in federal trouble with anything.
There is no staff to find this UNLESS people start pointing fingers which is what some on this forum do.
The best advice is to keep a low...
when i switched right to left hand used a late model clutch system. much more better.
FYI, the floor supports in a 60/70/74 are not level like they are required to be in a 75/79 series with fuel tank under the seats. Some mods will be required to fit these. The drivers seat will fit a suspension base but what do you do with the...