Recent content by rfwj

  1. R

    oil pressure gage low but mechanical test gage reads OK

    thanks. any thought on why my gage is reading low versus the video? new sending unit?
  2. R

    oil pressure gage low but mechanical test gage reads OK

    thanks. any thought on why my gage is reading low versus the video? new sending unit?
  3. R

    oil pressure gage low but mechanical test gage reads OK

    I have an 85 fj 60 with a 2f engine from a 75 fj 40. Runs well, but recently changed valve cover gasket, oil pan gasket, and side crank case gasket. Now the oil pressure gage reads low. I put a oil pressure tester on it. ran at 10lbs at idle and went up 10 lbs every 1000 rpm. so i think i...
  4. R

    should i change oil pump?

    i would only use a stock pump. i see them out there for $200. I guess if I rev and pressure goes up means it is working. i think it is rather binary. either the pump works or not?
  5. R

    should i change oil pump?

    I am replacing the oil pan gasket and was wondering if i should change out the oil pump. i do have really low oil pressure at 700 rpm. it does increase with a rev of the engine. like all these 2 f engines. will a new pump help at low idle? thanks
  6. R

    new fuji carb help

    I targeted 750 rpm as that seems to make all the stuff work well. Power steering, belts on water pump . I advanced the timing to barley seeing the mark in site glass. it seems to work well now. thanks.
  7. R

    new fuji carb help

    green. thanks. I think i blew a fuse too. Any advice on starting screw settings. idle speed and mix? thanks again.
  8. R

    new fuji carb help

    I just put a city racer fuji carb in. I think the idle solenoid is not working no clicking. fuel in site glass fine at 50%. How should i hook it up. Black wire to solo black wire. green wire to solo black wire. how should i check power to it? any help on initial screw settings would be...
  9. R

    carb help question

    thanks
  10. R

    carb help question

    I think you were correct. I disconnected the fuel line. sprayed carb cleaner. and the site glass filled. Now it is filled over the site glass but it runs well. But i am afraid it will happen again. how hard is it take the top off the carb and spray around a bit. should i set the float to...
  11. R

    carb help question

    Help. I have had this nice trolhole carb on an 85 fj for years and all the sudden not gas in the site glass. I turn the key and idle shut off clicks. Is there a way to get gas into the carb. I replaced the fuel pump and filter. so gas is getting there. thanks It will run sometimes then just...
  12. R

    New F & 2F carbs

    Help. I have had this nice trolhole carb on an 85 fj for years and all the sudden not gas in the site glass. I turn the key and idle shut off clicks. Is there a way to get gas into the carb. I replaced the fuel pump and filter. so gas is getting there. thanks It will run sometimes then...
  13. R

    VC removed. Do you have to have a CLD switch to make things work correctly?

    thanks i read somewhere you could see if a noise was front drive line if the front drive shaft was unbolted from the TC and then run the truck. I guess to make the rear work, you need the cdl locked to make the rear spin and move with front un bolted?
  14. R

    VC removed. Do you have to have a CLD switch to make things work correctly?

    The car drove to the drive way so some drive shaft maybe both were engaged working? there has been a weird TC noise on highway after 10 plus miles. low wine. to see if it is front drive shaft issue. Disconnected the front drive shaft and the rear drive does not spin or move the truck so I...
Back
Top Bottom