Recent content by pbuschbeck

My first choice was to go Toyota, but here in Peru, they are asking way too much. Any ideas as where to buy them? I searched but didn't find many parts for the 70 series. Thanks for the help

I am on the search of the rubber seals that go on each side of the doors and prevent water from entering the door and the window to rattle on rough trails. I have tried everything but with no positive results. Any ideas as where to find originals or a nice replacement? THX

Hi Does anyone has or knows where to find the position of the vacum hoses for a 1995 1FZ, non usa carburated engine. Thanks

A couple of peruvian FJ40

Great Info. Trollhole has the handle, already PM him. Thanks !!!!

Just bought my second 55, and I am missing the tailgate exterior hanlde. Does anyone knows of a good alternative replacement? Any shops selling them? Please don't say SOR, alreay been there Thx

Hi, In the look for a set of split rims I have run into 5 Nissan Patrol 16" Split Rims. Does anyone knows of some kind of problems into installing them on a 60 Land Cruiser? Bolt Pattern, Hub Width, Offset rubbing the caliper? THX

I begin the process today. Will take pics and post information of the process and the overall results. Thanks on the advice

3B is 3.4l and compression is 20:1

The question: How will the 3B perform with a CT12B turbo that came from a 1KZ engine installed in a 4runner?? Someone knows the figures for this turbo? PSI and working rpms?? I am getting a sweet deal on it, so I don't want to let it go.

Have you tried Prosport gauges?

One question, I am planning on doing the same to my 1982 3B engine. It has a linear diesel pump with no electrical parts, fully mechanical, and I was wondering if I can use this pump or do I need a new one before installing a Turbo system? THX

Thx for the help Tomorrow I am going to make the swap, don't have much time to repair the one on the 60, so I will hace to put a 40 trannie that lies on the floor. Will make comments of the process later to comment on any inconvenient found See ya

I have crawled underneath the truck and the spacer is not there. I guess you mean the spacer where the 5fth gear goes, also common on all 3f configurations. What's your opinion on the gearshifter? Are they compatible?

How difficult is to install an FJ40 1982 H41 gearbox into an FJ60 1984? I have noted the position of the shifter is different, in one it is forward, and in the other is in the aft. It is as simple as changing the top of the gearboxes? Thx