Well, I'd say that the height is partly the angle I shot from (as I said, I'm no photographer), and part that the bumper may be a bit deeper than most. I just took these pictures, that show that thebumper actually ends right at the rails and is just deep enough to grant some protection to...
LOL, hopefully I don't run into anything with it. That said I'm absolutely confident that I'll fare better than I would have without. I wanted an aggressive aftermarket look, that still flowed with the lines of the vehicle. Almost every aftermarket bumper I've seen fails to take into account...
here's some more pics, Sorry the poor quality, I'm horrible with a camera.
And there is currently no winch. I though alot about adding one, and in fact we have a winchbox ready to go in if I decide I want it, but it probably won't anytime soon.
Back when I first got my Cruiser I decided I wanted the look of both a brushguard and ARB bumper. It took a year and a lot of work, but the job is done :) It proved more cost effective to use my original brushguard and fab a new bumper to fit the guard. This also allowed me to dictate more of...
Switch which wires?
So I received the maf, but no instructions :( I've got the Maf and orderd the sensor from CDan. I HAVE searched but couldn't find the instructions on the forum. i need to know which wires i need to switch to install the unit correctly.
If you need to e-mail the info...
Let's see here, 12" sub in a sealed prefab box with a 2" setback, That's not just good bass, it's SMOKING! Good thing you went with that aught gauge wire, I'm not sure the system would cope without it. :rolleyes:
I call you and raise you 2600 square foot of ceramic tile, 2 bags of grout and 6 bags of thinset. After loading I was so pissed I didn't have my camera. That was a scary 5 miles.
If you read the chronology you will find that I was quite courteous until I got blown off and insulted. I spent some time typing my perspective to a person who writes a magazine for the cruiser world, a magazine that advertises itself as welcoming new ideas approaches etc. Sorry if I tried to...