Just to clarify, while holding the key to start, the engine is not attempting to turnover. Nothing abnormal with lights on the dash but after a few seconds of holding the key to start it suddenly turns over and cranks on immediately. Strange stuff.
Hi all
5 days before headed to Moab with the 100 series pulling a popup and my family of 6.... and I'm trying to chase down an intermittent start issue. I've searched the forum quite a bit and have trouble shot several items with no sustained success. Truck has 208K on the clock and I...
Looking for a couple items shipped to 80526:
1. Driver side fog light
2. Shifter assembly trim
If you can share pics of both, if available, I would appreciate it.
Thank you
Looking for a couple items shipped to 80526:
1. Driver side fog light
2. Shifter assembly trim
If you can share pics of both, if available, I would appreciate it.
Thank you
Interested in a quote for the following (located in Fort Collins)
1. small DS fender body panel piece (in between wheel well and front DS door)
2. DS fog light
Thanks
Interested in quote shipped to 80526 for the following:
1. small DS fender body trim piece (in between wheel well and front DS door)
2. DS Fog light
Thanks
Interested in a quote shipped to 80526 for the following:
1. small DS fender body trim piece (in between wheel well and front DS door)
2. DS fog light
Thanks!
Interested in a quote shipped to 80526 for:
1. small DS fender body panel trim piece (in between front wheel well and front DS door)
2. DS fog light
Thanks!
I started out by thinking that I had a leaking rear caliper.. lots of fluid/grease/caked $hit all over the rear hub, rotor, backing plate, etc. Fluid wasn't too low so I started waffling around assuming that if it was a leaking caliper that it fluid would have been crazy low. Assumed next...
Thanks @willbt ! Appreciate your response and providing pages from the manual.
After further inspection, I'm starting to second guess whether the bearing requires replacement. Of course I could be biased to either the cost of the dealer removing/installing or the effort required to take care...
Hey all,
Working on replacing the bearing and seals in my drivers side rear axle of a 2000 LC. Fort Collins dealer quoted $300 to remove and press new bearing... with the axle already out of the truck...
Anyone in the area have a SST or homebrew tool to pull the bearing? Or have a...