Recent content by mudnyreye

No glass, no problem. minor rust ok. need all hinges, latches etc. I do not need stays. shipping to Atlanta, GA Thanks

The Hatch w/o glass is o.k. need gasket. Shipping to 30307 Thanks

Looking for a "decent" WS frame. some rust ok, must be straight. $ + ship 30307 Thanks

Fuse block PM Sent

What is the Leaf spring frame pin diameter for a '69 FJ-45? 18mm? I know it is larger than the 40 series. I need to order some grease pins for an OMEmu spring set and need the exact size, Thanks

Looking for grease-able shackles and spring pins. 9/16" Pair of each.

I have one $75+ ship

I Have one 50+ship

Air blower box, Heater box with coil, Rear heater coil and motor (needs repair) Pulled from '79 FJ-40. Also included (not shown) are the blower to heater tube and brass connection tubes for the heater box and rear heater. $150+ship.

Fully functioning when pulled (3mo) drained and stored in a pyrex container with a little gas mixed with stabil. $100 + ship. I also have mounts, stock air filter mount and manual choke kit for xtra coin.

Used Centerforce. fits F and 2F. lots of good life on the plate. $130+ship

Works great. Direct drop in. $70+ship

Frame for '76-78 FJ-40. Frame was chem dipped, hand primed inside and out with POR 15, overcoated with rust o lium hard hat. needs some minor touch ups (scratches from moving around) Have title. Not going to finish this project $400 obo. pick up only zip 30102 ++++ lots more parts. Send email...

211K pulled from FJ-60. Ran great when pulled, no smoke, good compression. $300. you pick up. zip 30102. Send email for picks. 60 was diss assembled plenty of other parts.

PM sent