Recent content by maddss

@mudgudgeon Pic of the shaft, its toast

I'm still in that area

Update the drive flange is stripped. Hopeing I can get a 95-98 flange as a temp fix until I can get it to the garage.

Thank you all for the correct path to check the drive flanges and birf splines, hope the birf splines are not damage. I'll keep you all posted

@NeverFinis "Make sure your shift lever is fully going forward, and engaging 4H." Its all the way forward in 4H and I'll check the magnetic plug later today. But from the grinding sounds theres metal in there

94 LC with 268K I need help identifying if the transfer case is shot or the transmission. Transfer case in High - transmission in DRIVE or REVERSE, it barley moves with lots of noise coming from the transfer case. Truck does not hold in park, slowly moves any direction (driveway has very...

94 LC, is this the correct hardware for the front fender flare ? The other 2 are metal studs with 8mm nuts

@SUMMIT CRUISERS PM sent

Got it From this https://forum.ih8mud.com/threads/how-to-replace-your-seat-bottom-foam.504344/ The part numbers I am showing is for a 1993 with manual controls and cloth interior. 71512-60020 is the driver seat and 71511-60040 is the passenger seat. You will also need the rings to attach the...

@Akella Are these window runs still available

My problem was a bad #6 fuel injector https://forum.ih8mud.com/threads/rough-idle-mis-fire.1165295/#post-12638383

I had a similar problem, but it turned out to be the windshield gasket was bad. This might help. Look at this post for the part #'. https://forum.ih8mud.com/threads/rain-leak-into-cabin.293188/ sliding roof guide rail 63255-60010 rh, 63256-60010 lh

@george_tlc Just got to the back #6 injector While in the motor it was reading at 40omhs On the bench it’s at 20omhs. All other are st 14ohms.

@george_tlc How hard is the #6 injector to remove ?

94 LC 225k. Has a rough idle, runs rough and has a stumble as you drive. I installed new NGK wires, Denso plugs and factory cap and rotor. Also clean the throttlebody. Still have the same rough idle and stumbling. One at a time I removed each spark plug boot to determine which cylinder...