Recent content by lumpy70

  1. lumpy70

    1966 FJ40 preservation/build

    For your broken hinges, I used this guy on Mud for my 1980: https://forum.ih8mud.com/threads/quik-hinges-available.984408/ Not stock but amazing quality and finish.
  2. lumpy70

    '78 FJ40 3-point retractable seat belts - aftermarket opinions

    Is there any other solutions out there, anyone tried anything new?
  3. lumpy70

    Fridge Plug jiggling loose

    Never mind....answered my own question when I dug through the squirrel pile in the garage and found a locking 12V socket
  4. lumpy70

    Fridge Plug jiggling loose

    What are you all doing to keep the plug for the fridge from vibrating loose? Mine is supported and under no strain, but randomly wiggles loose and the fridge turns off.
  5. lumpy70

    Small propane bottles

    Why scarce?
  6. lumpy70

    Replacement Rocker Panels

    Any chance you are making these for 79 and up?
  7. lumpy70

    Builds Electric TLC FJ-40 Build

    What is the battery capacity? Where is it installed? Do you have pictures? Do you have costs for the package? What is the wiring between the battery and the motor like? Pictures? What is the cost?
  8. lumpy70

    SOLD 1978 Jump Seats, original, near mint (yes really)...in Canada

    Sold to Swamp Thing Thanks all for the interest.
  9. lumpy70

    SOLD 1978 Jump Seats, original, near mint (yes really)...in Canada

    Swamp Thing is first in line, I have been trying to get the time to box them up for size and weight so I can get a shipping estimate but work has been crazy. Based on the response, I grossly under-priced these! If the shipping is too much for the first in line, I will go down the list in the...
  10. lumpy70

    SOLD  1978 Jump Seats, original, near mint (yes really)...in Canada

    I have a set of pretty mint jump seats out of my 1978. I need shoulder belts and front facing for my kids, so these are up for grabs. Both have original foam, straps, springs, paint etc, and fully operational. Zero rust. Asking $500 CDN + shipping. More pictures on request. PM me if...
  11. lumpy70

    Rear body height from rear bumper

    Can someone with a '78 and up take a picture and a measurement of the height between the rear quarter and the rear bumper, as well as the side-to-side? I need that height to weld the interior of the rear sill to the quarter, it sets the height of the whole tub.
  12. lumpy70

    Builds Ziplock's revival

    Very nice
  13. lumpy70

    Need to properly treat my DIY alum table

    No expert, but clear epoxy, or clearcoat?
  14. lumpy70

    Official FRIDGE Thread

    Anyone know of Iceco vendors in Canada? All I see is from Amazon...
  15. lumpy70

    Official FRIDGE Thread

    @HemiAlex, what vendor?
Back
Top Bottom