Hey everyone. My lower power steering stud broke when I was removing the pump today. I'm guessing it was over tightened by a PO since it was able to keep things tight but I barely put tension on the nut to loosen it when the thing broke.
So just need to know the part number/sizing for the...
Lol I have all but 1 flare / flap not held on by gorilla tape. The flaps tag rocks and caused the flares mounting points to break.
That s*** is sticky! It's ghetto but it works surprisingly well. So I just did that for the rest of them as they fell apart. I can't see paying anything over a few...
Mine definitely don't dump the light fast. Especially when the brights are on. They also don't have a "beam" like the old halogens did. It's a very even scattering of the light which I really like, especially for the trails I find myself on at night.
The road sign thing I found interesting...
9006:
http://www.ebay.com/itm/311051865310?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
9005:
http://www.ebay.com/itm/321497943780?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Looks like the price for them went up to 85. Still better then the 250 most places...
Eh angry drivers dont bug me one bit.
They are actually pointed pretty low. They don't have a majorly noticable focal point like the silver stars do so it is difficult to capture on the Note 3 camera.
Had a couple friends over doing some CB install / testing for a trip were doing this...
Got them on and running. Took about five minutes.... Because I dropped my beer and had to go up stairs to get a new one haha.
Sylvania silver star ultra low:
LED low:
Mind you that is just plugging them up and going. No time to aim or any of that.
I actually had a silver star ultra high...
I've been trying to find the temp ratings for the kit I got. For me (while yes less is better) living in Utah, if they don't produce enough heat then they won't melt the snow/ice off like the halogens do.
Looking at the LED type on cree's site. The ratings are givin at 85 degrees so I would say...