Letting my Land Cruiser go. It's been a great truck, but I was ready for new. As with any vehicle this age, there are some issues, but it starts and runs reliably. There's a bit of rust under the driver's side passenger door, and a dent under where the passenger side bumperette was. I have...
I was recommended a tune up yesterday, but based on what people are saying, I'm not hopeful it will fix the stumble. Seems like it's getting worse, but still only up to 2000 rpm or so. Found a major tune up kit at cruiserparts with plugs, wires, cap and rotor, pcv, etc. Gonna do that next...
Did you ever figure out your misfire issue? Mine is doing the same thing. Started at the same time my brake booster went out, and I had a stuck open thermostat. Both replaced now, but still misfiring. Happens a little bit at idle, but bad on take off until about 2000-2500 rpm, then smooth as...
I had this problem last week. No CEL, no start. Turned out to be a loose/burnt EB1 connection. Thank you Christo for finding that. If you're standing by the driver's front tire and looking at the fuse box in the engine bay, my EB1 was directly between the fuse box and the engine, almost...
Thanks to everyone that replied! I eventually conceded defeat and took the truck up to Christo. He found a loose/burnt EB1 connector. She's back up and running. Gonna go find a trail tomorrow to celebrate.
I disconnected this sensor and tested the sensor for continuity, and the plug for voltage. The sensor was 3.6K on all points. The plug from top to bottom was 280mv, 56mv, 7.6V, and less than 10mv on the bottom. Any chance this could be why I'm not starting?
I just put the Duratrac 315's on. Maybe 1000 miles on them at this point. Had TerraGrapplers before. I'm loving the Duratracs. I haven't noticed any noise. Took them to the Jenny Creek trail and got to drive in mud, snow, ice, and on rocks. They did great.
Personally, I thought think...
Blinkerfuid....I don't have spark. I'm not sure how to test for fuel. I followed the instructions for diagnosing an ignition problem in the FSM. I'm at the point where I need to check the crank position sensor. I finally found it, but I can't get the plug apart. I do notice that some...