Remove door card, remove speaker, reach in and up to grab it to remove. Don't remember if the nuts are on the inside or outside but you get the idea. Easy
They unbolt pretty easy for replacement. You could try using some lubrication in there to see if it makes it better. I had one making some noise and gave some dry lube a shot. the past 4 months or so have been nice and silent.
if it is hanging up at all, change it out, it has been a few years but there were reports in the tech section about the doors being broken from limitors being stiff.
I shot it with some Silicone Spray today. It's clicking and I can feel it click with my fingers on it. As well as seeing the mount on the frame kinda vibrate when it clicks. I don't see any part of it broken.
Success! Sorry in advance, as this post is gonna be a bear (and no real pictures either), but for those like me who want an easy to follow guide to install a stereo, I think this will be worth it...
Simple Cheap Stereo Install (w/Amp Bypass)...
Just tossing my 2 cents in here for posterity...
Like many others I just wanted a cheap, quick, easy solution to be able to make and answer calls while driving (a necessity for my job), play music via bluetooth, and add a backup camera if...
Follow-up for posterity. A Ground Loop Isolator for RCAs (GLIRCA) kit reduced hiss and hum down to zero WITH THE KEY AT ACC. As soon as I turn it to ON, the hum returns, and turning the engine on results in wholly unlivable interference.
I hate...
Not as fancy as others but I have been running two of these for two years with no complaints:
https://www.batteriesplus.com/productdetails/battery/sli/bci-group-31/sli31sa
On a side note: In most municipalities laser needs daily calibration and a certified person operating it. In GA usually one of those boxes is not checked due to time and cost to perform both. If you get a laser ticket ask for proof of both and...
They are very much. In NJ 95% of the time it’s KA band. And if they are shooting laser I’ve seen them using KA as well. I travel the east coast and it’s rare a cop is hiding only shooting laser. It’s not just for speeding ticket avoidance but...
I was looking to do the same thing the other day thinking how easy it would be. Then I looked at it and it's still not installed yet. I have a mirror tap ready to go if we can find power from there.
There's a box to the right of the mirror, I...
I have a Cobra radar that I installed in my Avalon. I don't have one in my 100 series but the install was very similar to what you're wanting to accomplish. For my Avalon, I found the wiring harness that goes to the mirror and controls the auto...
I have a Valentine One Radar detector I just bought. I have a 2002 LC
I need to pick switched 12v somewhere near the mirror or bring it to the mirror. The wire will be a flat telephone type wire.
Has anybody tapped into the mirror...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.