Good day all
Just trying to get a quick opinion on extending diff and gearbox breathers.
I've been searching to see if I put the rear diff and the gearbox breather into 1 if there is any negatives to doing so.
I want to run the lines into the engine bay and use a T to join the rear diff to the...
Hey all, I bought an 1997 hdj80 with h151 to swap my 3fe and auto trans out my 1992 jdm cruiser.
My question is I have seen where the part numbers for 91-92 are different of that of the 93+. Can the 97 pedal set work in the 92? Or do I have to source a 92 pedal set?
Regards
Dan
Good day all,
Happy new year.
I'm having an issue with my a440f transmission. When I just bought it and restored it. It was fine. I then had an overheating issue and then the clutches started to slip.
I got the transmission repaired and rebuilt. After the rebuild when the transmission shifts...
Hey all,
I installed some 1inch spacers on my kzj70. The front studs length is ok but the rears stick a little past the spacer so the rim can't sit flush on the spacer.
Anyone know what studs I can switch to. Or if the front studs can work in the rear. Assuming that the fronts are shorter...
Has anyone ever put a h151f behind a 3fe?
I noticed the 1fz from a 70 series. The clutch disc is the same size diameter 275mm and not 300mm like behind the 80 and 105 series.
And as far as I know the 3f bellhousing should fit the h151
Hey all. I've been trying to do some research on the ATF. My fj80 requires dex II but that's not available in my country. I had done some work and some of the atf leaked out. So I had topped it up with a little T-IV but now the transmission takes a while to engage (possibly slipping too) I have...
Hey all I've been searching and searching for info on the manual conversion for 3fe.
As far as I know the 3f came with a h150f and also the 1hz. But I'm getting info that the 1hz uses a 21 spline shaft vs the 3f thst uses a 10? I have access to a 1hz h150 box but I can't seem to find much info...
Also do you know of anyone has a solution to of the adjusters stop working or the gears wear out?
I'm an over thinker and I think of all worst case things to happen. And just feel better knowing there is a solution to if It does get f###ed especially since it's a 30y/o head lamp.
Hmm interesting. I was looking options incase mine need to change. I was testing them today (vehicle yet to be driven) and I realized my right headlamp isn't as bright as the left. So I'm changing the bulbs to led to see if it makes a difference. Or I'm not sure if that how they were designed.