Recent content by KansasFJ62

This thread is very helpful. My horn on my 89 FJ62 works but it's so faint you can barely hear it. If I'm driving, it's so hard to hear. I wonder if that's because the PIN is worn? At first, I was thinking the problem is the actual horn but now it sounds like maybe the PIN.

Headlight door

Headlight door

Headlight door

MomoMoto....I'd buy you a beer if I could.....clearly a picture is worth a 1,000 words! Well, I got the job done and it works. The problem is I installed in the same location as the previous owner, assuming it was correct... And now I can see why they replaced it, as it's definitely kinked a...

hook for speedo gear?

remove to make easier replacing speedo gear

think I installed the speedo gear in wrong spot

Yeah...I skipped that step, hopefully it’s not a big deal.

One update - I was able to pull the yellow end of the cable from the bottom of the cruiser, thru the hole behind the gear shift, and up to the speedo. Took some leverage with the back of a hammer but it popped thru. I think the issue was I connected a rope to the yellow part of the speedo...

I am trying to pull the whole speedo cable from under the truck, thru this hole which is located behind the gear shift. I’m having trouble getting the yellow cap end thru this hole and then up to the speedometer. The yellow cap doesn’t seem to fit, but not sure I’m going from the right direction...

Speedo cable

Hole to thread speedo cable

Ok....3 hours into this project and no success yet. Try to put in the new speedo cable. Tried starting from the odometer, down towards the gas pedal, thru the grommet, and then back to transfer case. Couldn't fit it all thru the grommet. Then tried the reserve....duck taped a rope to the...

So the easiest way to replace the cable is to pull it from the dash, thru the grommet in the floor, and then underneath to the transfer case correct? I was thinking the reverse, but appreciate any tips. I read another post that he went from the dash, down; not from the bottom, up.