I was comfortable with trying the Champion.
Packaging was very good and survived UPS. The tanks were not perfectly parallel when I went to install, Champions website explains how to correct this. Installed 2 years / 14k miles ago with Dorman 49450 bushings, Denso cap, ground wire and swapped...
This hits home, just went through this during my wiper rebuild.
With all the changes made already, I would remove the wiper arms from the studs entirely as you work to find the proper (original) clocking position of the small arm on the splined wiper motor shaft. Put a ziptie on one of the...
I can verify 5.250 inches from bolt center to bolt center on the box section 2.5 inch shackles (P/N #288-42) that came with my lift. I can also confirm the springs at the time were made by Standens in Canada for SOR (circa 2002 installation date). The springs ride firm, I opened up the spring...
Real quick check, take the vacuum line off the fuel pressure regulator and check for fuel in the hose. I'm not familiar with VW's but if It's the 2.0 8 Valve, the regulator should be on the fuel rail and to the left of the intake runners. Real easy fix and a dead ringer for hard starts like...
Well my cruiser has officially left the garage today (insured, emissioned and licenced after 2 years of sitting) so I figured I would introduce myself. My name is Patrick and I have a 74 FJ-40 with the typical 4 inch lift, crappy paint and 33's. I am a Mechanic by trade (god, I hate the "M"...