Recent content by JohnnyBoy

trade a one for my bj60 turbo. very little rust and solid drivetrain. im asking 8500

1984 bj60. 1984 turbo, lots of work done, espar heater i will get some pics soon. $8500

i've got an espar so starting is not usualy a problem, however i have a 3/4 tank of b100 in there right now and its about -20. i guess she will be sitting for a while. i drasticly overestimated my driving. ive been on the same tank for about 4 months now. now because i rode my bike in the fall i...

i gotta get me a boost sensor. ive been afraid of adjusting mine. i have heard that it makes quite a difference.

sweet i wanna do mine but $$$ you know

aprox 1b

ive got one here in calgary its on my truck but im not using it, i could get off my hungover @$$ and get it if u would like.

im runnig b100 right now and i would like to continue a fairly strong mix throughout the winter. i was thinking of setting up an aux fuel tank to run my espar heater, then plumb some lines right next to fuel line. i would like to drop a loop into the tank and then return to the engine to preheat...

im running 123 hp with an atx turbo. the PO who put mine in paid about 2000 for the kit, installed it himself and then took it to a shop with a dyno tester for set-up.

i think its 99 cents at the pump.

i got it from agri-green in sparwood. i have a place in slocan valley so i pass by all the time and fill jerry cans. i was getting tired of that so i asked about other options. they have 50 gallon drums and 1000 liter tanks. they run a fuel truck to calgary every month or so. the price depends...

i just got 200 galons of bio diesel delivered. no more jerry can runs through the mountains. i live in calgary, if any one would like to give it a try let me know.

x2 on the air bags. most spring shops have acsess to them. i put them on my old half ton pick-up, about 300 bucks but well worth it especialy if you have on board air, you can hook them up and adjust as needed.

just did the same, milage is down a bit but well worth it.

when mine went i cut open my oil filter and put the paper pleats in a vise to remove the oil. sadly a bunch of silver shavings on the one side.