Recent content by Hwn built

Wet Okole makes a seat cover for you.

That happened. Flushed system first, then changed fan clutch. Been good ever since...

I'm looking for the green. Not sure what the side molding is or what, but this is what it looks like. I popped most of it out with a stock car jack. I'm going to try pull the rest with a slide hammer, bondo, and do a cheap touch up. I might be able to fiberglass the fender flare back...

Thanks ElJefe. I wish Cruiserparts had some clear lights in stock. Maybe in a few years tghey'll update their page.

I just went sideways going up a mountain road while it was pouring. I almost flipped my Land Cruiser but luckily I only went into the bushes. I went maybe 30 feet in and so far the only damages have been the passenger side running board, passenger side mud flap, drivers fender and drivers side...

Do you have that wire or no?

I know you mentioned the doors as gonners, but do you by any chance have the stock wiring from the factory speaker to the connector(short piece, just need side that is connected to speaker). So yeah, don't need speaker, only wire and plug. Lemme know please. thanks.

6 bolts on the bottom. Several for the gas tank. . . Easy 30 minutes with no rusted bolts

I see one around my side of town every now and then. Swapping the engine isn't much trouble. If I remember right, it fit with the 4 spd. If the bellhousing is different(most likely not), then yeah.

Ok, I didn't check the 2 or 3 other threads, but I have a 6" JL in place of my stock one. To me it wasn't worth it. If I had to do it over again I would just re-do the whole system since I needed to add an amp and seal the JL in a seperate box. And it is still not enough bass. Check page 2...

I have Michelin LTX 265/75s with about 50,000 miles on them. My spare is a 275/70 which is taller, but skinnier. The first time it touched the ground after leaving the showroom floor was couple weeks ago. Found out that spare is alil f'ed up. Kind of burnt and the sidewall is indented. In no way...

I've had several similar problems. One time all the electricals was off. Found out it was some wiring harness(forgot which ones, but have it written down somewhere in the folder). Another one was when I was coming home from wheeling. Came from mudding and went to fill gas. Wouldn't start. Found...

Landpimp, when they took apart my seat and put it back in, they had it too far forward. I'm not the skinniest person and I like to sometimes just sit back. I asked them to move it back 2"s. It's still on it's track with the stripped gearbox. So they didn't move the brackets around, they just...

You got any LX450 corner lenses?? How bout the automatic shift knob?? Let me know. Thanks.

Well, today I picked up my Cruiser. Yes, 2/25/04. Well, you probably have read the thread when I took my Cruiser in, and I mentioned that I was going to do it myself if it wasn't done. Well, I chickened out and had Toyota do all the work.... Hose, air Cleaner(bellows boot) + shipping +...