Fairly simple question, although the answer seems illusive! Simply want to figure out the location of the steering box on the chassis to work out bottled hole locations. Perhaps as shown in pic
I need to weld some new spring plates on my doffs as the centre pin holes are ovals out. Can any tell me what the pin diameter is? Stupidly I cannot measure off my springs as I got rid of them. I suspect that the hole should be 19mm diameter?
Hi Mohawk. I am dropping a 15b into my 40 series. I have added a turbo, custom injector pump and 12v conversion. Should be mounting within the next month.
Hello All. I am doing a glacially slow frame off resto on my 1983 40. I am currently blasting and painting the wheels (original 16" split rims).
The tyres on the truck were 7.50x16. I have purchased 235/85/16 BF Goodrich KM2. My question is, can I reuse my tubes? They look to be in good condition.
I have made a little progress on other bits and continue to chip away when I can find the time. I am about to blast the wheels and mount the KM2s - not a big job - but I think the new look will egg me on.
Next on the list is sorting the engine chassis mounts, rear gussets and cross member...
Progressing at turtles pace! A year since I last posted! Jeezz!
Here is the new and improved turbo'd version of the 15b - finally got it running again this weekend after the clean up and turbo conversion.
I'm in Auckland. And there are a few others here too. Saddam Husain and Tom are in Wellington. Auckland is a great place live as HJ61 mentions. You want to live close to where you work, as traffic is s***. Takes me 12 mins door to door on the KTM which is perfect. House prices are huge - with...