Heckraiser

Wrapped her in Army Green. Have to reset my brain from seeing it go from white to green

In for 1" kit whenever these are ready to ship. Let me know how to pay :hillbilly:

looks great. That's a sweet pickup you've got there too.

And this, ladies and gentlemen, is how axles break :hillbilly:

Patiently awaiting the body lift thread.

first trip for the year. Went to va for the weekend. 1000 mile trip ran great

Spent a day on dirt with my dogs, experimenting with adjustments on my minty fresh new Dobinsons MRR shocks. Did just over 100 miles in total, and found that empty boat ramps make for a fantastic and repeatable damper test rig. I did 6 passes on...

Next to a LC300

I got the White line 30mm HD rear sway bar installed. I used Landtanks HD stock links. The sway bar axle bracket was a bit tight and wouldn’t line up with the threaded bolt holes. I had to bend one side with pliers and used a Dremel to elongate...

Nolathane 30mm rear sway bar installed tonight. Visually a bit more beefy than stock for sure. Quick drive around the block shows a noticeable reduction in body roll. Will report back how it feels when I drive up and down the mountains this...

Was putting my ‘92 back together after a deserved full paint job. Clear coat was starting to fail after 32 years. I made new door cards and upholstered them while the 80 was at the paint shop. All that’s left is repainting the front bumper...

Shortened the front end up mine over the weekend. The Trail Gear bumper sticks out super far. Cut the frame rails back 2 inches and trimmed an 1 1/4 inches off the bumper at the top plate and sides where it would run into the radiator support...

But you see them everywhere... at least I see them everywhere. They are the most notorious for undersizing their tires, but people keep buying them!

Into the Woods. Happy Tuesday!

Yet BFG remains one of the best selling tires on the market... :rolleyes:

I don't normally like those either, but I think the grill looks pretty sharp on your black truck 👍

Today, I finally put those slee steps on. The little swivel socket they recommend in the instructions was so great to reach the upper bolts…until it exploded and I had to repair it with a tension Lin from the hardware store. After the repair, I...

1st run of 1” and 1.5” in aluminum for test fitting. Initial fitting appears to be perfect 🤌🏼 (Don’t worry, those Napa rotors are for my Chevy Express 😉)

The hypothesis holds true - the more you play with it, the bigger it gets. Mild 3/4" body lift for the moment.

Hello everybody ;-) It hasn’t been a week, exactly but I’ve just collected my car from the wrapper last night and put on the new tyres today. - satin wrap, dual colour - alloys renovated and powder coated in satin black - rear “LC” decor, rear...

@Dekeman @BurntToast 861 is the best color and I won’t be convinced otherwise. It still looks good with patina too…

Took 'er on first drive of 2024. Up to small Quebec town where the bakeries and pizza shops were open. After rebuilding the entire rear axle and replacing brake booster and master this winter, was keen to test out. Drove sooo good. New booster is...

I love the look of the F5, and that probably would have been my wheel of choice if you could get one in a 17 that fits a 200.