Recent content by hanzo111

Thank you. I’m installing a bikini top until I paint my doors and top.

Thanks! No fender lights. I added a wire to the bib lights and use them as both running and turn signals. Search my posts I have a write up.

Oh yeah! I just have to adjust the clutch send it off for exhaust and wheels. I have to decide on which wheels I’m probably going stock with 32s

First drive after rebuilding

I ran a 2gc on my 250 inline chevrolet. nothing but trouble for me. its sitting in a box. 5 internal fuel pressure regulators, 3 02 sensors 2 tps, sent back once and still never worked correctly. I went back to my Rochester monojet and couldn't be happier.

Man, that is not a big deal. You can do it yourself. SPI is the makes the strongest epoxy primer and is used by almost all corvette restorers and the company is owned by a legendary corvette guy. their epoxy primer will seal all of that and is actually stronger than gel coat...

They are 19 yo 33x12.5x15 on headlocks I have had this truck in storage for 14 years. But still holding air. Pro comp X terrain I would like to trade the whole set of 5 for stock wheels

oh yeah she does. She kept asking what to get for this build. (she buys a part for all of my builds so she can point to her friends and gloat) agreed on the winch, then she calls me and says "after researching I'm buying you the synthetic rope version because you are too flaky to remember to oil...

Installed my winch that my girlfriend got me for my birthday, it was frustrating because the previous owner installed the power steering box a bit higher than he should’ve. But I think it turned out really nice.

I figured it out. was pretty simple. one light socket didn't make a good connection and interrupted the circuit. I had cleaned the whole board and scuffed the connections with 1000 grit and de oxit but i missed a tab. thanks for the help.

Yes

Good points. The clear is only on the metal outer fascia. Yes the ammeter is bypassed fully. The gauge receives power for all other functions except powering the area of the circuit board that powers the bulbs. Fuel gauge registers 3-4-8-9 are definitely functional as the turn signals work...

Thanks for the reply, The ammeter connection is connected well and double heat shrunk. all fuses are new and fuse block has been scuffed for good connections. I will check the ground of the face plate to the body, I did clear coat the face of the cluster, I will test with a wire and scuff the...

I searched and didn't find any posts regarding the issue I'm having. 1976 fj all stock except sbc swap. I disconnected my amp meter and wired the white blue wires together bypassing the meter as I am running a 140 amp alt the gauge cluster gets power from the harness plug, my fuel gauge works...