The EGR can be disabled without a plate. I do not know the process on your 94 but many here have done it. I wanted the equipment out of the engine bay as I already had other stuff that had to come out for my PM anyway, so just went ahead and made the backoff plates and removed the pipe from...
SOrry for the late reply Rob. If I recall, It would be pretty hard to get the bolts out to pull the EGR tube that bolts to the back of the block with the upper intake plenum in place. I however do not think that capping the rear heater lines requires removing the EGR. It is just a tight place...
I did paint over them. Then used sand paper to sand the new paint off after it dried, and then clear coated. It’s all still holding strong. The paint job was not perfect, and I was wanting this thing back up and running for work the following week. All in all the engine compartment still...
Life hack, divorce is cheaper than losing a finger in many cases.
Also I am enjoying my Shortbus. Does anyone take any measure preventing theft of bumpers? Didn’t want to weld the bolts to the new powder coat.