I sometimes get stuck on the Health Check selection in the Virtual window. By that I mean I can’t stroll or move the windowed box low enough to select that I want to perform that Health Check. Does anyone know how to solve this issue?
Okay I believe I fixed this issue.
I also got Techstream to read the ECUs, not sure why it didn’t last time but this time it worked. I also read a bunch of codes that were stored I’m guessing before the ABS module was replace. So I cleared those, no stored codes. TRAC and VSC lights were off as...
Hi everyone, I’m having another issue with my 01’ LX. I recently had my ABS module replaced due to a supposed bad chip and was sent a remanufactured one from ModuleExperts. I had the usual ABS/TRAC/VSC lights on and determined it was the module.
Upon reinstalling the new ABS module. The lights...
Thank you for the help, unfortunately it looks like my laptop does not support VT. I cannot find it in bios. Should I try something else in the article?
Also in VB settings, it gives me errors for VT since I assume my system does not support it. It will not let me apply the settings when I...
I’m having an epic failure of a time trying to get this to work. I have followed the steps in the original post exactly. TS won’t boot up in the VB and gives me an error code immediately. I tried on my old MacBook Pro. Then booted up my Dell laptop. Did the exact steps and still nothing. It...
Thank you for you post, very informative. If you look back a couple posts I just finished the repair myself, rides great again! Now time to figure out what is wrong with the OBD port...
I would like to thank you all for your knowledge and expertise. Undertaking something like this is not something I was very comfortable with, but you all helped pushed me to get it done.
I purchased 4 new globes for $1,100 and 4L of AHC fluid for $100. It took approximately 4 hours, not rushing...
Hi all,
Issues I’m having on top of the AHC, is not being able to connect to the car. The port has power,(checked fuse) but when hooking up the scan tool the error pops up. Has anyone had a similar issue or know how to help diagnose this problem? I’m not sure how long the issue has been there...