Recent content by Fzjrvakma

How hard is it to find a base model with 4x4 these days?

Hey all, can someone confirm whether this steering wheel was stock on the 1980 model? I can't seem to find any information online so any input would be great. Non-US?

Thank you. The valve itself is not available anywhere. Do you know if another Toyota check valve will fit?

Hey Knuckle, did you figure out a way to avoid the external ballast?

Hey all, I've got what appears to be a Dorman check valve and grommets (2) on my OEM booster but cannot locate a repair for the failed grommets. They fall out of the hole in the BB and I'm having to use gasket maker to keep it in place. I can't even find a source for the original parts for...

Thanks man, but pardion hooked me up

I am looking for the vertical plate with the ball knob on it that ties the heater linkages together on a '76. Mine is on the left in the below photo. Let me know who or where to look, as Cruiserparts.net is a no go. Thanks!

I've got a knock that I can feel in the steering wheel and only when I turn left. The steering wheel can be at any position and as soon as I turn it left there's a hard knock that hits the steering wheel. I've tested it with the knuckles detached from the steering linkage. It only seems to be...

Anyone know of a good source for replacement reservoir on a '76?

If you're rebuilding both knuckles and more than likely pulling oil out of the axles when removing the birfs, doesn't it make sense to include checking or changing the diff oil? Newbie here

Is there a need to seal the connection between the fiberglass and the visor, outside of the rivets?

Does anyone have some input on why these areas tend to be trouble spots on the FJ? I assume water runs down the back of the roof and down the rear face of the panel, into the groove? Combine that with water intruding into the side seams of the side panels and rolling to the back, rust then...

At this point I just want normal tight steering and I don't want to have to do any welding. What's my best option? Can I do the FJ60 without having to weld anything? Planning on going no bigger than 35 inch tires and don't need anything real crazy in terms of off-road capability. Just beach and...

Hey all, see photo below of how my windshield is sitting in relation to my door these days. WS is not in place on the door at the moment, so I'm assuming this is all due to an old windshield gasket that isn't compressing fully? Dash screws are fully screwed in too.

Any of you guys see a problem with me doing one side at a time? I've got a tight garage and I'll have to back the truck out and reposition in order to pull each CV.