My buddy is sell his 87 4runner 22rte it runs but needs some love great project asking 2500.00$ OBO But will take 2200.00$ His Name Is Matt You Can Reach Him At: 801-529-3526
High Book Is At 4000$
1987 Toyota SR5 Turbo 4-Runner.originally bought it to make a rock crawler. but no time, and...
Ahh Duuude... Thats Sucky
First Off, You Should Clean The Mud Off So You Have A Clean Frame To Work On, Also Wire Wheel Like 2nd Gen Said... Also Check For Thin Metal (Rusted Section) Take A Punch And Hammer To Check For And Further Weak Spots.
This Looks Like A Stress Crack From...
2" Iron Pipe Was The First One, 2" DOM And HREW On The Second One.
I Think 1 3/4" Is Now What There Going To Use From Now On Just Because Its A Pain To Bend 2" In The Bender.
It Would Be Nice To Post Some Pictures But Some M3tal D0rk Stole My Memory Card TO Post Some Pictures About A Signal & Parking Light....
So....
Engine Is Re-intalled
New Clutch Is In (Stage 2 [6 Puck Ceramic Disk And 1600 lb Pressure Plate])
Removing T-Case From Tranny Tomorrow...
Pull On Drum Brake Housing After Removing Brake lines. Pull Third, Install axle shaft to keep seals good, and install brakes lines
Place Into Parts Washer, And Clean
Welded Spider Gears (Six Spider Gears In All) Replacing With Spool
This Part On Is If You Are...
Remove 12mm Nuts And Lock Washers, Also You Can Use A Standard Screwdriver To Pop Off Lockwashers In Case They Are Stuck From Silicone Residue.
Drain Third By Pushing Up On Third, Or You Can Use A 22mm To Drian From The Drain Pluc On Bottom Of Third.
Use Vice Grips To Clamp Line So hardly...