X2
Have mine off right now for HG replacement. Simple green in hot water + 800 grit with flat aluminum stock and wd40 on gasket surface. Turned out great.
Just fought the harness out for a HG job where was this tip yesterday?! Just kidding, great tip, fighting old connectors was the Bain of my existence yesterday. Now on to replacing all the injector connectors those were very brittle.
Can someone give me some pointers on how to disconnect transmission temp connector. Assuming the release is the tab at the top of the connector but no dice so far. Trying to do this non-destructively. Thanks.
Just acquired a supercharger. Hoping someone can confirm what is the part number for the throttle body gasket and is it the same part for both the throttle body and the intake runner?
I have found two part numbers labeled throttle body gasket...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.