having dramas with my centre diff lock switch its a 91 80 series has switch on dash can hear relay under dash but no light on dash i replaced the switch on transfer but still no luck , ive done the paperclip test it came on replaced the switch still doesnt come on dash oe hear motor on...
i done the paper test on my cdl switch on transfer and it works but tried to source the napa part in australia no go here can anyone help or am i paying toyota overinflated prices
im trying to diagnose a fuel problem with my 3fe cruiser it runs on lpg but not on unleaded, ive bridged diagnostic and can hear fuel pump but seem like not getting fuel has anyone encountered similar and rectified :):bang:
just wondering ive put a replacement engine in and trying to work out top dead centre and fit distributor does the 2 dots on crankshaft matched and 2 dots on flexplate indicate top dead centre or just 2 dots on flexplate as this and valve adjustment any help appreciated:bang::bang:
ive started getting ready for 2fe swap on my 80 series my question is the crank pulley on 2f do i swap with 3fe what size bolt on crank also do i use 3fe water pump any help appreciated:bang:
wanted good running 2f or 3f engine would even consider just a 3f crank if someone has one or old worn engine located adelaide south australia cheers shane
hi guys ive bought a non running 3fe and have found a good used 2f just wondering if many guys have done this as 3fs are harder to come buy ive been considering v8 conversion but wife wants it running also how much of a pain is a 50mm bodylift on an 80 series
i just bought a fj80 auto 3fe cheap with a broken crank i was looking at a v8 conversion but have found a 3f engine cheap can i use the 3f bottom end with 3fe head the 3f was in a manual any diffrences in crankshafts :bounce:thanks shane
selling some parts have set of 73 landcruiser doors complete no rust key etc $150 ,full turbo 350 automatic trans with marks adaptor kit suit chev/308 with driveshafts to suit $500 way below cost located in adelaide also have an 82 rust free chassis suit ute $150 rear diff complete $100 all...
hi guys im looking at fitting set of light force spotlights and there is old wiring which is hooked to headlight relay and a switch on dash when i tried it didnt work is there a more reliable way to wire up
re lights
thanks heaps herb had a look at colum and noticed wire had come out of plug quick push and lights on if only new that b4 replacing everything lol least shell go for anoth 30 years regards shane:clap::cheers: