Recent content by erobinson32

  1. E

    Another Fast Turn Signal Thread

    Ok, this was a lot of help. Thank you. I'm back up and blinking with a (hopefully) temporary fix. I tested the voltage on the 9pin (left-side) and 10pin (right-side) of BU1, and both tested at full +12v, as I hoped. I then checked the voltage entering the trailer socket. The left side was...
  2. E

    Another Fast Turn Signal Thread

    Wouldn't swapping right/left in step 2 have eliminated this? I'll check it against the body whenever it stop pouring outside. Wasn't doing that. 10-4, I saw someone in another thread say they were turn signals. Good to know. Never even knew there were bulbs in there. Thought they were just...
  3. E

    Another Fast Turn Signal Thread

    No, but it looks very clean to me. Not corroded, and is making good contact with the bulb. Should I disassemble the socket and clean?
  4. E

    Another Fast Turn Signal Thread

    I know there are several threads on this issue, and I have read every single one that I can find. But, haven't been able to fix the issue yet. 1997 LC. Left blinker blinks twice as fast. The left rear bulb does not flash. No LED bulbs anywhere. The problem started about 3 months ago, but was...
  5. E

    Right Front Clicking/knocking - Mostly after Left Turns

    ~115 miles since my last update, and the clicking/clunking noise is still gone. Glad for that, but frustrated that nothing was fixed. Very low confidence it's not going to come back randomly when I'm far from home.
  6. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Had my buddy that has a lift look at the brakes (all fine). He could not reproduce the noise up on the lift, which wasn't surprising because I couldn't either up on a jack stand. But, when he drove it he thought it was coming from front left, not front right. I still think its front right...
  7. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Correct. Haven't heard the grinding since. The spindle bushing was very difficult to remove, but I got it out using a tutorial I found here on mud, and installed the shorter busing and needle bearing (oem). There was some minor wear on the surface of the old spindle bushing, but it hadn't...
  8. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Certainly seems like it to me while driving. Took the wife around the block a couple of times and she agreed it seemed to be coming from front right. I really do appreciate all your thoughts. I think I might get someone with a lift to check out the brakes in the front for me to be sure it's...
  9. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Ok, busy afternoon. Had a couple of spare lock washers and so I just took off everything down to the outer wheel bearing. I then re-installed it all back as per @BILT4ME suggested above, with increased torque on the inner and outer nut. Clucking is still there on a trip around the block.
  10. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Thanks. I lifted the front right off the ground and wasn't able to reproduce the noise by rotating by hand in neutral. If I find time this afternoon, I'm going to open it up and re-torque the nuts.
  11. E

    Right Front Clicking/knocking - Mostly after Left Turns

    OK, back from a test drive. When I got the clunking noise, I applied the E-Brake and the noise continued. I could not re-create the noise in reverse. I also shifted into neutral when the clucking was happening, and it did not go away. Thought it might only happen under load, but that...
  12. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Yes Yes Yes 47 ft lbs on the locking nut I mostly followed this guide. ~35min in.
  13. E

    Right Front Clicking/knocking - Mostly after Left Turns

    Thanks. A hard right turn will usually make the noise go away. No noticeable drifting. Braking does not make the sound go away. I have not tried the E-Brake, or in reverse, but will today at lunch and report back. As far as recent service the only work has been what I mentioned earlier...
  14. E

    Right Front Clicking/knocking - Mostly after Left Turns

    It's definitely consistent with MPH, not RPM. Once it starts, it might continue for minutes, including downhill without giving it any gas. I can slow down (slowly) and have the clicking slow down with the MPH, all the way to zero.
  15. E

    Right Front Clicking/knocking - Mostly after Left Turns

    A few months back I had some random, but scary, grinding in front right in my 80 (1997, with ~280k miles). Here is my previous thread: https://forum.ih8mud.com/threads/front-grinding-with-busted-nuts.1277918/ Thought it was either the wheel bearings or spindle bushing, so I replaced the...
Back
Top Bottom