-
-
emr88 replied to the thread 285 spare tire on gen 1 sequoia?.Looks good @efjayatee , which Rigid Armor model is that? -
emr88 replied to the thread Dobinsons 2.5 Inch IMS Lift Kit Question.Would like to know how you like them, 1st gen or 2nd gen Sequoia?
-
emr88 replied to the thread 285 spare tire on gen 1 sequoia?.I've managed to stuff a deflated 295/75r16 under there, but it rubs the panhard bar a bit. Rubs just enough to make it sound like an 80's Cadillac with bad shocks/springs. Is there a spare tire carrier mod for the 1st gen Sequoia?
-
emr88 replied to the thread Replacement springs and shocks for OME 2" lift?.Dobinsons GS59-683 Pair of Front Shocks for Toyota Land Cruiser 80 series 1990-1997 for 0-3" Lift Dobinsons GS59-682 Pair of Rear Shocks for Toyota Sequoia, Land Cruiser 80, 100 and 200 series 0-3" of Lift Sounds like you do need new springs...
-
emr88 replied to the thread Replacement springs and shocks for OME 2" lift?.I installed an OME 2.5" lift kit on my 80 in either 2005 or 2006, so pretty close to what you have. The shocks got progressively worse over time. I replaced them with Dobinsons and the ride is so much better now. As BILT4ME already pointed out...
-
emr88 replied to the thread FZJ80 on 285-70-R17 - FJ Steel wheels..I ran FJC Steelies with 285/75r17 (34") Falken's for a while. They fit absolutely perfect (IMO) with a 1.75" spacer. I was running BORA spacers .
-
-
-
Didn't see a lot of info on the Coastal Off Road Rear Bumper Kit so wanted to make a post about it. I put it on my 96 HDJ81 with the OEM tire swing out. Reached out to see if they had a military discount and Daniel got back to me and offered a...
-
emr88 reacted to WoodsmanNC's post in the thread Put pictures of the wheels you have in yours 80 series with
Like.
17 inch Toyota FJC steelies.. 😎 -
I’m really happy with my decision to get F5’s. Here’s a couple photos from this year.
-
emr88 replied to the thread Weld it Yourself 80 Series Tire Carrier Assembly Instructions.I love the design of your tire carrier, and the fact that you offer it both in a weld it your self and a built system. It looks incredibly stout, but I have a question. I see that it's cut from 1/4" plate, but why is the spindle sleeve only 3/16" ?
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
