Looking to purchase any of the parts for TRD supercharger add-on to my 1994 Land Cruiser. I'm in CA so not a lot of other options for engine upgrades. PM me if you have any of the parts available for sale. Thanks!
--Dylan
Hello all, I was diagnosing two wet plugs on my FJ80. Ordered two OEM injectors from my local Toyota dealer, went to install them and realized someone has swapped the injectors on my car. Anyone recognize these Densos? The height and shape matches an 06 Camry I think.
Does anyone here recommend...
Here's a short update. I ordered a setting ring 100.0 mm (measures 100.010mm according to my optical CMM). With the dial bore gage zeroed on that, the maximum measurement I got was on cylinder 2, 100.03 mm in the transverse axis (perpendicular to the crank) and 100.01 mm in the longitudinal axis...
My concern was that I’ve only owned it for the past 30k miles, and I don’t have a lot of service documentation, so I was concerned that someone in the past tried honing and replacing the rings rather than boring out and getting new pistons. I guess knowing the absolute diameter numbers would...
Yes I have a Mitutoyo. Unfortunately I don’t have a setting ring or micrometer big enough to calibrate it with, so I could only use it for out of round and taper.
That seems crazy to me that 200k plus mile blocks still have cross hatching. Did Toyota use softer rings than typical? I’m used to vintage American cars with lots of cylinder wear by 30k miles.
Hi All,
I have a 266k mile 1994 Land Cruiser and I'm trying to decide how badly my engine needs the cylinders bored out. I pulled the head because I had a head gasket leak at #6 cylinder. The head has been rebuilt with new valve seals.
The block looks like it was honed at some point by the...