Recent content by DownTheRoad

Not Safelite, and not New Mexico. There are good reasons New Mexico is 48th out of the 50 states in many categories. If you're not from New Mexico and come to live in New Mexico, be prepared to exercise extreme patience and restraint.

I got the windshield replaced with OEM but it took 4 months to get the OEM part in, and despite being assured they would replace all the mouldings, they did not. So I still have the moulding pop up every now and then. I should have went to LEXUS Dealership. Sadly, 1 months after getting the...

Need to replace 2010 LX windshield and I have the same channel molding problem. Safelite quote for OEM (acoustic) windsheild is $1550, but I am thinking I need to get all of the trim pieces for the windshield, because my moldings are shot. Anyone have experience with Safelite replacing all the...

I changed mine by popping out the lens and replacing with the LaFit led bulbs. You adjust the mirror with your hand, to make room to access the lens.

Has anybody tried installing one of these on the floorboard between front and 2nd row?

The molex connector should have 4 connection points in one row. You need to put the Ground in the far left box, and the positive wire in the far right ignition on box. The last picture shows the black ground and red positive taps installed in the molex for the rain sensor. Looking up and...

I installed a radar detector today tapping into the rain sensor molex. I also explored the option of tapping into the rearview mirror auto dimming molex. I have a 2010 LX570. In each instance the far-left wire was the ground and the far-right wire was the ignition on/off line. In both cases...

Good to know. I did TS and got an abnormal oil level code when trying to raise one of the front wheels (forgot which side). I still have to get the rounded RR accumulator off, so I'll do a little more bleeding and hope to bust off the last accumulator today and get everything at least...

Reservoir is at Max and cannot go into LO. I've extracted about 2L and add about 2L. All fluid comes from the front bleeders, and nothing from the rear bleeders.

Thanks, @radman . Going to try my luck using Techstream (which I just got and still learning). I'm in a little AHC hell right now, particularly since I rounded the 4th final accumulator just a couple of hours before sunset. PITA. So, back at it tomorrow at sunrise, plus I'll add in the bleed...

Thanks I'm going to get at it tomorrow morning.

What is the procedure for calibrating the VSC?

I was replacing all 4 globes until one for rounded, so I'm kinda trying to figure out how to get the RR accumulator off that rounded. Meanwhile, I am not able to go into low mode, so I think I need to bleed the one that is immediately after the pump. Anyone have a photo or quick shortcut so I...

@nwfl4runner Thank you for sharing your knowledge and experience. I came across your post after inquiring how to replace the "rubber donuts" which I thought were bump stops, but learned they are sway bar bushings. This should tell you I have zero experience in this area. Yet, after reading...

@TeCKis300 Thank you for the part number and exploded view.