Cat litter works great for soaking up oil spills and it's cheap, comes in 50lbs bags, and can be bought just about at any grocery store if there's no pet store around. Brake cleaner will work wonders at getting the remnants out of the concrete.
Had a similar but unrelated oil spill kinda like...
I'm at work but here's a suggestion: Email wholesale automatics in Australia and they may be able to send you the information you're looking for. They specialize with land cruiser transmissions. Wholesale Automatics
Good Luck
Need early model fender flare.
Mounting points must be intact, don't need the hardware like clips and such.
Part number is molded into the flare and should read: 53088-60901
Thanks
Gord
Check air intake clamps after turbo as well as intake manifold for lose nuts. I just about had all my intake manifold nuts come off one time, causing me to lose all boost pressure while highway driving. When I finally limped home I found most of the nuts sitting on the block around the...
I've done this rebuild using a similar kit however what they don't include is the second bearing that's inside the vane rotor. It's a small needle bearing and when I pulled my pump apart and separated the shaft from the rotor some of those needle rollers were snapped in half and the shaft...
Hey Somebody,
Here is a crosspost link to what I found for replacing the valve: HDJ81 Heater Control Valve
The cable is still available and fairly cheap, just use the part number in the picture above and order one. I got mine from jp-carpart.com.
Cheers
Gord
Sorry I forgot about this post! So I got the valve that my father brought back. It functions the same as the OEM. To use you’d have to remove the new arm via the one screw and put one from your old valve on. As long as the key shape fits the old arm it would be a direct replacement. Here are...
Gonna chime in on my experience doing this. I had a hell of time getting the tension spring back hooked back on the post. I struggled for about a good 30-45mins trying to do the screwdriver method with no luck and gashing my hand pretty good.
I gave up and wandered my garage thinking of a way...