Recent content by Crochunter

I once found out the hard way about aftermarket master cylinders. Put two in and no pressure, put in an OEM and got immediate pressure. Something to consider before purchasing parts.

Anyone know if someone sales a rebuild kit for our brake master cylinders? I found a company based in Australia but a note says for non-ABS only. Thanks!

Update to my issue. For anyone who experiences this problem here is what you may encounter. The new OEM fuel pumps apparently have narrow male pins and the female connector receptacles were slightly wider so that no connection was occurring. After disassembling the connector and squeezing the...

Are you getting any codes? I’ve recently had similar symptoms but I had a P171 lean. I removed the intake manifold and cleaned all clogged ports, replaced all hoses, cleaned my fuel injectors, new fuel pressure regulator and still had problem. Finally had someone put a gage on the fuel system...

Put the old pump back in and it started right up so power is getting to the pump.

Just curious if anyone has an answer for this. Recently acquired a 97 that developed low fuel pressure from a weak pump so ordered an OEM from toyota part # 23221-66040. Put new pump in and nothing. Pump never powered up. I noticed the old pump was physically a little shorter than the new pump...

Hope to soon make a meeting and meet some like minded cruiser heads. Just bought this 97 fully locked 80 for a steal and can’t wait to fix her up.

I would have to say it was at a normal crank.

Haven’t dug into it yet. It has sat for quit a long time. Last time driving it starting began to be an issue but I thought maybe a fuel problem was beginning to happen. It has 2 batteries and I had charged both. Thought maybe one battery wasn’t charged enough maybe causing the problem.

The passenger side negative battery cable melted during repeated start attempts. Starter seemed to work but no fuel ignition. Any ideas of cause?

I have driven through the cycle many times and each time the code will trip and all three still will not go into the readiness mode.

Ok! I have hit a wall on this and am still scratching my head. So far, I have done all that I know to do. I've pulled the intake manifold and cleaned it extensively as well as the throttle body. I replaced the egr and modulator valve, new vsv and vcv, and replaced all hoses. I've gone through...

97' 40th Anniversary FJ80 "SOLD" Very clean cruiser w/ 191,000mi. I hate to part but I am buying a house and need the extra cash. This cruiser runs like new after the work I've put into it. It has a new radiator, new viscous coupler, belts, new crankshaft seal and oil pump cover seal. Also, I...

It doesn't have the lockers but the A/C works great.

Here it is!! Only asking $$ 7500.00!! It has 191,000 mi. however, I have done quite a bit of maintenance and have it running like new. I'll just give a quick run down of what I have done to it. So far I have put in a new radiator, a viscous coupler, belts, new battery, new plugs/wires, new...