Cruiser for science in the Kisatchie National Forest, LA this weekend. At one point I misjudged the lack of solidity along the shoulder of the road. Had to winch out.
I did too many things at once to tell. I was in there, I cleaned all the stuff in the intake (completely locked up with carbon), adjusted the valves and sealed a bunch of vacuum leaks.
But the injectors were certainly bad.
It runs great now....
I have a low milage 3FE from a 1988 62. Truck has a bad frame and parting it out. PO drove it only for around 2K miles an ear for the past 15 years (have records of it)
I didn’t do a compression test per lack of time and mostly Knowing te...
That's it. Just clip the tip with a smaller hole first, run the A's and then clip a little larger and run the gutters. It's a DTM product as well, so don't need to primer if you burn through the paint/primer on prep, just don't leave any bare...
These had to be custom ordered from Europe. When I checked, none of the major manufacturers of these style window screens made them for 80-series. I ordered an extra set as a spare, which i no longer need. Had to wait 6 months for them.
Very high...
At this point that is the plan yes. Maybe if my parts/shipping department grows I will have time to break things down to smaller kits, it is hard to compete with a some of the other behemoth vendors selling individual parts so at this time the...
Gates catalog.
I bypassed my rear heater and used 3 of the Gates 28466 hoses to do it, which you can see all 3 here, cut as needed. If you're still using the rear heater then you'll need 2 of those and you'll probably need to google search...
I'm due to change out the pump I installed in my initial post. That old Dremel took a dump completely back then, which prevented me from cutting my old one open, but I'm going to dry out and weigh the current one once it's changed out and this...
So I do a bit of leatherwork, and I made my own Leather steering wheel cover for my FJ40.
I'm starting the process of making one for my Fj 60.
My plan is to (slowly) document the process here on this thread so other folks can do it too.
I'm...
Hadn't driven the 60 since last Nov (I leave it on a trickle charger) and since today was a nice day, I though I take off the cover and drive around for a bit. Drove very well for about 20 mins, then all of a sudden, truck just stumbles and...
I’ve done several 80 frames. Mild heat, brass pipe cleaner style brush, and a high quality tap set. 8 hours to do all of them. High quality tap will save you broken taps in the end.
I was skeptical of these armrests when I started seeing them on Instagram. However, I looked at the One Stone website last week and saw they were on-sale. I decided to take a gamble and order one figuring that if I didn't like it, I could...
Two sets available here.
The upper set of seven in each photo are older wrenches of the two sets, with the TOYOTA MOTOR forged wrenches being earlier than the TOYOTA versions. The TOYOTA MOTOR version became available in the 1970s through I...
These are the modern counterparts to the vintage tools I typically offer. All in perfect condition. $89, which includes shipping to the US. PayPal F&F please. Will be posting a vintage set with more pieces shortly.
Heritage parts program is a JDM-specific marketing program. It was never meant for non-JDM markets which is why you can’t get these parts in the US.
It is a marketing push to keep the LC in the eyes of buyers by showing Toyota’s dedication to...
Super nice condition. The longer 17-19 is a thinner tappet-style wrench, although I'm not sure if Toyota actually calls it a tappet wrench. $45 for the set, which includes shipping to the US.