I am new to The area and would like to join in on the ride if it’s going on and you all are willing to take a newbie to the group along. Are the details listed anywhere?
I am throwing in the Hella housing until I can get around to upgrading the harness to do the complete upgrade. For those that have not done the harness do you use the short adapter that comes with the Hella's? I read that it was plug and play but not sure if that means with the short adapter...
My rig is titled as a 90… manufacture date is a 10/89… out of curiosity does anyone know what the cut off is to be considered a 1990? Any chance my title has the wrong year?
So I tried the rear defrost this morning on mine when I needed it and no luck. How are you all trouble shooting to determine if it is the grid vs power vs switch? How do I test to make sure that power is going to the grid (and if it is how much should it be)? There is a little black box on...
Hey need some help. Trying to find some information on this Cruiser. I am told that it is a 1985 BJ40. Could not find anything that lists the Color codes, engine codes etc for this year to verify that it is what it says it is. So what do you guys think...
1) I thought 40's stopped in 1984...
I just put a weber 38/38 on my 2F engine. I am trying to figure out how to hook up my Valve cover and PCV? They both went to the air filter on the original but I have only one connection on hte new. Suggestions? Thanks!
I am installing a weber 38/38 on a 2F engine. I know that the lower right is the fuel inlet... but I am not sure what the one on the upper left is. Please help! The directions keep talking about a connector to the break booster but say that is on an adapter. Is this connection for a break...
Each of the bearings have a tab...both top and bottom. Starting to geuss that the ones the shop ordered for me are for a 2F. From the pics I can see in the 2F manual they have tabs.
yes,no maybe so?
Ok Guys... need some help. I am doing my first engine re-build and had the machine shop order all the parts for me after doing the machine work. I am getting ready to install the crankshaft and am looking at the Main bearings and wondering if I have the wrong ones.
The ones I have each have...