Recent content by Cape York boy

So it turns out, Im a retard! I had managed to swap over the 87 connectors for the right side inner set of wires. I wasnt even going to update and just delte the thread and pretend like it never happened. But i was raised to own your mistakes. Hopefully if anyone else has similar problem they...

The trick is not getting caught:cool: Bit hard to hide the led and they are a sure bet of being pulled over. ps giant spiders aren’t illegal. They are in the garden. Along with the taipans, croc, scorpions etc lol. We don’t need them as pets.

Unfortunately LED’s are still not ADR compliant here. I don’t want to sound like a wet blanket but they shouldn’t be used. That’s not to say I think they aren’t the best product and shouldn’t be approved. I just want the best product that’s not going to get my vehicle taken off the road. The...

Greetings, I have used the wiring diagram that may have come from another site, but having issues. Im guessing most people will know the diagram im speaking about. The high beam stays activated after dropping back to low beam. Its obviously being fed from somewhere it shouldn’t. The other thing...

Sounds like fuelling. If it's not set up right you can be flat out making 1500rpm in 1st. Why don't you start at the start and be systematic in your approach. It will take a bit of time but not as much time as pulling out a stuffed engine or trying to diagnose a problem over and over. Start...

Hi all, Timing belt let go on the 80 and did not end well. Engine is being rebuilt. I started a thread over on 4wd action and thought it would be of interest. Link below. If this breaches rules I'll remove and copy content over. Any feed back welcomed. Cheers Mat...

Hi all, Done the head on my '92 1hdt 80 series with Gturbo. Was looking around and came across these heads Toyota 1HDT Complete Cylinder Head Kit - OzTradez Has anyone had anything to do with them? They probably all come out of the same factory anyway. They do off 12 month warranty for...

Not much has been mentioned about how or where to get bigger injectors from to match these pump mods. Perhaps it could be mentioned in this thread instead of starting another. If it starts getting technical then New thread it is. But if it's as simple as: get yanmar injectors and have them set...

All is very clear now. Your figures (particularly early boosting) are similar to those on the spec sheet with (cc/200st). All that had been crossed out and obviously 1000st figures recorded. I would be interested to see the torque and spool difference of the free flowing housing vs standard. As...

Hi Yotahead, Are those figures at the injectors? I had my pump set at 50% when reco'd and that is about 97.5cc. Pump was done on the bench. I have the spec sheet if anyone wants it. If running a GTURBO 50% as a minimum should be achievable. Perhaps I have misinterpreted the...

There is nothing to scroll. that is the info Bosch sent me. At least it is a starting point. I tried getting a list of different available pins but they won't help. I had imagined a nice little picture with all the available pins. I pulled one out of an old Nissan it had 15.5 stamped. Very flat...

That's from the Bosch mob who incidentally will not help you and will fob you off to local dealers who won't want to help either( not that I blame them).

I have been tinkering with the pump. I could not really get the travel I wanted out of the old spring (19mm) so had two new ones (26mm and 30mm) made ($35 Cairns Spring works, free plug, good to deal with and can make anything). I also tested the springs to see how the performed under pressure...

Yotahed, How is your pump going. Have you got an update for the forum? Has anyone else come across info on the other sights for cummins etc for these secret recipes for internal mods to this pump. The Americans define over the top and there a lot of sled trucks etc pumping out...