when replacing axle seal / rebuilding knuckles, do you need to get an alignment once everything is back together? I will be rebuiding both knuckles and swapping birfs from side to side. Would it make a difference if you did or did not disconnect the tie rods from the lower control arm on the...
the spindle isn't cracked, it is definitely a gouge as a result of something. Like someone took a massive flat head and gouged the crap out of it??
@Tools R Us ...when you say it is worn enough that the seal chamfer is gone, are you referring to at the base of the spindle, the first step...
haven't been having any problems found it while replacing wheel bearings. Do however have some clicking on that side when accelerating up sharp turns in parking garage - preparing to to axle rebuild and swap sides.
For anyone who is interested, I just switched out the oem Michelin ltx m/s 275/70/16 with Nitto Ridge Grappler LT285/75/16 on my stock suspension 1995 Land Cruiser. There is no issue with clearance at all (as many other posts have stated in the past). See before and after pictures below. Ride...
Update...changed the diff oil (see picture below of old oil & magnetic plug)...also added about 6oz of cv grease in each. Will check everything again next weekend. Thanks everyone for the input.
Thanks for the replies. Based off this thread and my other one, I plan on cleaning up both assemblies, check the grease level and add moly along with changing the diff oil. Then see what a week of driving does with clean assemblies.
Planning on using Mobil 1 gear oil and sta lube cv joint...
Bought the truck about 6 months ago. Was checking the brake pad wear and snapped some pictures of the knuckles. This is my first car with this setup. Is this normal or does it seem like time for a rebuild? Last knuckle rebuild was 20k ago (8 years ago).
First two are driver, second two are...