Recent content by bouncin betty

'84 FJ60 4 speed trans. pulled for motor trans swap. Transmission works fine. I will ship on your dime. I will be at cruise Moab and could deliver. $250.00 970-729-3316

I have 2 rolled Tacomas, 2003, that I am parting out. Motors and trans are gone from both as well as the locking differentials. Many interior parts are available. Body panels are destroyed except the drivers side doors on the white one. Those are in great condition. I do have fender...

This setup was in an 84 toyota pickup. Hope that helps.

Bump bump it

Turbo 350 transmission and adapter to gear driven toyota transfer case. $350. Buy the small block chevy and propane kit also listed in here and have a complete drive train minus the t-cases for $850!!! Would work great in your 60 series or your fj40 970-729-3316

Propane kit for a small block chevy. This kit is totally complete. even comes with 2 full tanks! These are well over $800 new. I will sacrifice for $500 and even throw in a 305 motor to go with it. Motor runs great and is set up for early timing advance. WHich is waht propane wants...

Sorry they are Detroits. how did I miss that. They are for the 4cyl diffs.

I have 3 One with cosmetic damage from a broken pinion.........locker works fine. $200.00 One with little use.........works fine. $300.00 One is installed in a 3rd member.............I would prefer to sell the entire 3rd member..... 4:10 ratio. $700.00 I can ship on your dime...

front axle shafts for 97 4runner. good cv joints and good boots. $50 bucks for the pair. 970-729-3316

I have a front differential from a 97 4 runner..I am not sure of the ratio. It came out of a vehicle with the 3.4 and automatic transmission. $200.00 Pm me or call 970-729-3316 Shipping would be on your dime.

Lockers for Toyota mini trucks 79/85 One used Detroit Locker Cosmetic damage from a broken pinion. Locker works fine. $200 One used detroit Locker No damage Works great. $300 One Detroit Locker never used. Installed in a 3rd member. I would prefer to sell the entire 3rd...

I have axles that I am going to use on my buggy. I pulled them a long time ago. I don't recall what they were from. They were from either a 60 or 62. THe vehicle is long gone. How do I identify what axles these are and what ratio they are. Thanks for your help.

Working on a customers truck (2000 4 runner limited) It has the nice climate control options. It seems the controls have a mind of their own. It changes modes with permission etc. Does anybody have any ideas on where to start with this? Is there a seperate computer for the cliimate...

Make sure you have SOME tongue weight on the trailer or else the "tail will wag the dog". Not fun. Your 60 should have no trouble pulling that load 20 miles. As long as it is not all uphill. Even than it will pull it. Just not very fast. Have fun and tow safely.

Voltage regulator Your voltage regulator is either part of the alternator or a seperate piece on the inner fender or firewall. In my 84 pickup it was on the drivers side inner fender and was simply a matter of removing the bolts that held it on the fender and then disconnecting it from the...