Recent content by BobBJ74

Very tidy.👍

I've seen worst. It's mostly surface rust from what I can see in your photos. Check rear cross member behind rear bumper and body mounts. The under body behind the rear alex is the area that sems to be most affected. Over here 120s only have rust protection outside the chassis rails and just...

Have you looked at AFN front bumper ? It dos'nt protrude out as far the Aussie bumpers.

Thanks again. My local tyre shop guys d'ont have much experience with lifted 4x4 alignment, so a bit of trial and error!! But we will get it sorted.

Cool drone footage. Pity about your tent.

Thanks for that info. Had them set at the recommended +2 degrees but had excessive wear on tyre outer edge. Going for alignment tomorrow, I'll post my results.

I've lifted my 120 with Ironman 2 inch B rated coils front and back and installed SPC upper control arms. Should I use the factory camber, caster and toe values for realignment? Tyres are BFG AT 265/70/17. Thanks.

Check out, afn4x4usa.com

Yes, AFN make bumpers for the 70, Prado 150, LC200 and Hilux which is the same as a Tacoma, AFN were at SEMA , there is video on YouTube of their kit on a Tacoma. It looks like the front fenders on GX 470 are different at the front compared to the Prado 120. You would probably have trim the...

Some more!

Photos of AFN bumper.

The grille on the Prado is attached the hood and closes down on top of the factory plastic bumper. I installed an AFN front bumper on my Prado 120 a few weeks ago and did not have to trim the fenders. I had to trim the black plastic splash guards under the fenders to fix to the new higth of...

Have ironman 2" lift with foamcell shocks. Used SPC upper control arms for their adjustability and strength. Truck handles very well on twisty back roads.

JC, wher did you buy the TDR alloys and what offset are they ? Thanks in advance.

Just dropped a pin. Hi from Ireland.