Ian,
Hope all goes well with Kelsey's Grandfathers surgery.
Which gas station is closed in Olancha?
Do you mean the Mobil Station just before Hwy 190?
Joe
Randy,
I am most likely going in on Friday night - 90%
You can tag along if you like............I drive really, really, slow, so it could take awhile :)
If I go, I generally leave about 7:00pm, as I prefer to drive the desert in the evening/night
Everyone have fun tomorrow - I won't...
Mark,
The morning report shows the road is closed due to INYO county road work.
Hopefully they won't leave the heavy equipment blocking the road at the fallen boulder location, which is roughly at the Grapevine / Hunter Mountian junction
I will be coming in late Friday night / Sat morning...
Ken,
Found a blurry picture of the OEM sending unit wiring.
I still need to connect George's Relay & the OEM switch!
Do you have the wiring schematic you used?
What type of connectors did you use to connect to the switch terminals?
Ken,
I installed mine similar to CM's.
I used a dial caliper to determine the drill bit size. It is critical to get the drill size as close as possible to the OD of the nutzert/rivnut.
To install the nutzerts / rivnuts....I used bolt, washer, tool, Star washer, & nutzert / rivnut. The...
SC,
Panamint Springs Resort is in the northwest section of Panamint Valley / Death Valley.
The Resort is in approximately 30/40 miles from Ballarat Ghost Town or the access point for Pleasant Canyon, Goler Wash, South Park Canyon, etc. These routes allow access into the upper elevation of...
Yes - the rear differential is the same, and will fit the 40/45/55/60 cruisers full floater axles. USA cruisers [40/55/60/80(90-93)] have full float fronts & semi-float in the rear, while other non-USA cruisers had full floating rear axles
You will need the longer spline axle shaft to utilize...