Pulled out the transfer case. Getting ready to play with 111 lbs. of fun!
Did it in the drivrway. No easy task. I have probaby done over 1000 sit ups over the past week!
I also did both high and low range gears from @cruiseroutfit through @ACC Toyota . I LOVE THE RESULTS! I have stock gears in the pumpkins and run 315s. The truck is a joy to drive now. I had forgotten what it was like to accelerate up hills...
Frog Bayou, western Ozarks. More technical than I expected, and gravity and traction defeated my confidence and I high centered on a shelf I should have stacked rocks on. Apex winch (and some rocks) for the save. Luckily drive shaft was unscathed...
From the FSM, brake section:
PARKING BRAKE LEVER
ON-VEHICLE INSPECTION
1. CHECK PARKING BRAKE LEVER TRAVEL
Pull the parking brake lever all the way up, and count the num-
ber of clicks.
Parking brake lever travel at 196 N (20 kgf, 44 lbf):
4 - 6...
Rear brake job with a few surprises...I was doing the brakes because a bad grinding noise started that I assumed was worn pads. It was really bad though with constant drag on the brakes it felt like so I thought it might be bad. Was surprised to...
It's been a while, not many crazy updates but figure I'd post!
ARB Combo 2003+ Installed with ARB LED Fog Lights
Bilstein B8 5160's
Dobinson's Adjustable Rear Control Arms (Upper and Lower)
Rebuilt Swing Out Spindles.
2700K Interior LED's
35L...
I started my cruiser one cold morning and when I turned on the heater I got the vibration from hell in the blower motor. I immediately knew what it was since I had seen mouse droppings on the top of the radiator and battery. When I pulled out...
My LX was missing the owner’s manual when I bought it last week. I registered it on mylexus, and found a spot to request a manual. Look what showed up in the mail today!
Regarding cable size, it isn't really that important. When you are jumping starting a car the cables are mostly charging the battery rather than powering the starter. The battery powers the starter. Smaller gage cables may just take a few more...
The look you get when you have a good bumper, but you order another one and she laughs...I married the right woman
Ironman to ARB completed :) :beer:. Winch and side markers still need wiring, but pretty much set.
Edit: I guess I should have...
Ok, I guess I'll be the one to ask about the armrests:
How do the arm rests stay in place? I looked on their website and saw the metal flange that slips in by the window seal but how does the rest attach, sticky tape?
They look like a really...