I ordered a few of these seat belt eyelets designed for securing harnesses in race cars. My hope is they will give me a few more places to secure things in the back of the cruiser.
An absolutely awful idea.
If you’re intent on swapping, might as well go V8. 1uzfe if you must have toyota. Chevy variant otherwise.
Or if you have to have a 1fz then swap rigs.
Try a search for steering shaft seal, been discussed for over a dozen years:
Did it for you this time:
https://forum.ih8mud.com/threads/hot-drivers-feet-this-may-be-your-fix.476570/
Finished plate assembly bolted in with the new OEM firewall gasket prior to the seal being bolted in. If you look closely, you can see how well the seal is centered over the mounting bolt holes. Don't mind the FIPG mess - If you've replaced...
I got a 2.5" body lift and I think I just realized the source of the small clunk I get in the drivers floor board and gas pedal that is noticeably worse in cold weather. It is probably my steering shaft contacting the rubber. When it is hot...
Best option will be to buy connector, seal and pigtails as a kit from Balenger. Or, just buy connector, terminal and seal. They have multiple options.
They are dirt cheap and OEM quality, and the old connector housings aren't likely to survive...
@fjbj40 ,
Thanks again for your help! I would have never have come across that wire harness repair manual on my own. You saved me a lot of time and, like you said, I found the gold plated pin terminals, seals, wire loom, and a few other...
Thanks, That's really helpful.. I had some issues with crappy injector connectors from Amazon when I did my HG, that wasted so much time I swore I would only use OEM housings going forward. So many of them being sold online are crappy quality
I've been there before, and either I am overlooking it, or it has literally everything except for what I was needing.... It's a long-ass post will look over it again later tonight. Thanks
Thanks for your help, I might not have been specific tho... im seeking the little copper terminal and seal that crimps onto the wire then clips inside the 90980-11144 housing. (Without the wire attached and without the plastic housing. Was...